Specification
- It dries quickly
- It creates a hard and flexible film, which is resistant to weather effects, water impact, industrial and automotive oils
- It has a high resistance to exploitation load and intensive cleaning with detergents
- It emphasizes the natural beauty of timber
Sphere of application
It is intended for decorative and protective coating of new or previously coated wooden surfaces (walls, doors, window frames, columns, terraces, garden furniture and fences, floor). For exterior and interior use. It can be used for the varnishing of mineral base (bricks, decorative stones, concrete).
Content
Technical data
| Consumption standard of 1 layer | 80-125 ml/m2, depending on the type of surface and way of application. |
| Thinner | Universal thinner TM Maxima.The varnish is ready to use and does not needing dilution. ATTENTION! Do not use white-spirit, solvent or others similar products. |
| Application | Apply with a brush, a roller or a spraying gun. |
| Drying period (23 °С, 50% RH) | 15 min. Drying period increases if the temperature is getting down and relative air humidity is getting higher. |
| Solids content (DSTU ISO 3251) |
29-30 % |
| Density (DSTU ISO 2811-1) | 0,93-0,94 g/сm3 , depending on the gloss degree. |
| Gloss (DSTU ISO 2813) | matt – max. 30 GU semi-matt – 30-60 GU glossy – min. 100 GU (at 60º) |
| Hardness (DSTU ISO 1522) | ab. 80 sec , Konig pendulum. |
| Warranty period | 18 months from the date of manufacturing. |
| Packaging | 0,75 L, 2,5 L |
Gloss
Color
Application instruction
1. Surface preparation
The surface must be dry (maximum humidity is 20%), clean carefully from dirt, grease, dust, blue stain, fungus and etc.
Remove resin in the areas of knots in a mechanical way or with a thinner.
To receive a smooth surface without visible places of old paint or weak coats, it shall be totally removed from the surface in mechanical (with a scratcher, a floor scrubber), thermal (a hot dryer, infra-red rays) or chemical way (paint removing treatments).
Polish the surface with small-grained sandpaper and remove dust.
2. Priming
Previously untreated wooden surfaces should be treated with varnish and thinner at the ratio 1:1.
Mineral surfaces need no undercoating before varnish application.
3. Applying
Stir the varnish before application.
The varnish shall be applied in 1-2 coats.
The application of the next coat shall be provided in 15 minutes.
Edges of wooden surfaces shall be treated more carefully until they are completely soaked.
Besides, the application is performed at the temperature from + 10 °С till + 35 °С and relative air humidity no more than 80%. Do not apply the varnish under direct sunlight, strong wind and atmospheric precipitation. After the coating is applied it shall not be affected by atmospheric precipitation for 24 hours.
4. Tool cleaning
Clean tools with a thinner after application. Do not let them dry. If necessary, clean them with warm water and detergents.
Flow calculator
Consumption standard of 1 layer
When calculating the area to be painted, you need to subtract the area that will not be painted. (windows, doors, etc.)
Paint consumption may vary depending on dilution and uniformity of application of the paint.