Express Wood Varnish Maxima

Express Wood Varnish Maxima

Maxima

Express Wood Varnish



Specification

  • It dries quickly
  • It creates a hard and flexible film, which is resistant to weather effects, water impact, industrial and automotive oils
  • It has a high resistance to exploitation load and intensive cleaning with detergents  
  • It emphasizes the natural beauty of timber

Sphere of application

It is intended for decorative and protective coating of new or previously coated wooden surfaces (walls, doors, window frames, columns, terraces, garden furniture and fences, floor). For exterior and interior use. It can be used for the varnishing of mineral base (bricks, decorative stones, concrete).

Technical data

Consumption standard of 1 layer 80-125 ml/m2
Thinner Universal thinner TM Maxima.
Application Apply with a brush, a roller or a spraying gun.
Drying period (23 °С, 50% RH) 15 min.
Solids content (DSTU ISO 3251) 29-30 %
Density (DSTU ISO 2811-1) 0,93-0,94 g/сm3
Gloss (DSTU ISO 2813) matt – max. 30 GU
semi-matt – 30-60 GU
glossy – min. 100 GU
Hardness (DSTU ISO 1522) ab. 80 sec
Warranty period 18 months
Packaging 0,75 L, 2,5 L

Gloss

glossy matt semi-matt

Color

colorless

Application instruction

1. Surface preparation

The surface must be dry (maximum humidity is 20%), clean carefully from dirt, grease, dust, blue stain, fungus and etc.

Remove resin in the areas of knots in a mechanical way or with a thinner.

To receive a smooth surface without visible places of old paint or weak coats, it shall be totally removed from the surface in mechanical (with a scratcher, a floor scrubber), thermal (a hot dryer, infra-red rays) or chemical way (paint removing treatments).

Polish the surface with small-grained sandpaper and remove dust.

2. Priming

Previously untreated wooden surfaces should be treated with varnish and thinner at the ratio 1:1.

Mineral surfaces need no undercoating before varnish application.

 

3. Applying

Stir the varnish before application.

The varnish shall be applied in 1-2 coats.

The application of the next coat shall be provided in 15 minutes.

Edges of wooden surfaces shall be treated more carefully until they are completely soaked.

Besides, the application is performed at the temperature from + 10 °С till + 35 °С and relative air humidity no more than 80%. Do not apply the varnish under direct sunlight, strong wind and atmospheric precipitation. After the coating is applied it shall not be affected by atmospheric precipitation for 24 hours.

4. Tool cleaning

Clean tools with a thinner after application. Do not let them dry. If necessary, clean them with warm water and detergents.

X

Flow calculator

Consumption standard of 1 layer
min
max

When calculating the area to be painted, you need to subtract the area that will not be painted. (windows, doors, etc.)

Paint consumption may vary depending on dilution and uniformity of application of the paint.