Oily paint MA-15 - POLYSAN

DekArt - - Oily paint MA-15 - POLYSAN

Oily paint MA-15

Specification

  • coated surface is reliably protected against auter impact
  • attractive decorative appearance

Sphere of application

It is intended for coating of metal, mineral and wooden surfaces.

Technical data


Consumption standard of 1 layer:
140-240 g/m2
Diluent:
thinner ТМ "DekART", white spirit, solvent (Nefras С4-155 / 200) or their mixture.
Application:
Apply with a brush or a roller.
Drying period (DSTU ISO 9117-5):
24 hours
Solids content (DSTU ISO 3251) :
88-90%
Density (DSTU ISO 2811-1) :
about 1,5 g/сm3
Hardness (DSTU ISO 1522) :
about 12 sec.
Warranty period:
12 months
Packaging:
1 kg, 2,5 kg, 60 kg

Color

white
yellow brown
yellow
green
red brown
grey
bright blue

Gloss

glossy

Application instruction

Surface preparation

The surface shll be dry and clean from the dust, dirt and grease.

Remove old flacking paint, and also also loose layers from the hard base layer mechanically (a scratcher, a wire brush), thermally (hot air fan, infrared radiation) or chemically (paint removal solutions).

Holes, cracks or uneven areas existing on the surface shall be treated with a putty for wooden and mineral surfaces TM "Fabex".

Treated sirface shall be polished with fine-grained sandpaper till smooth surfaces. Abrasive dust shall be removed and then undercoated.

Priming

Previously coated wooden surfaces need no undercoating.

Previously non-coated  and/or plastered wooden surfaces shall be undercoated with alkyd wood-protective primer TM "Delfi". Make sure before coating that the surface is completely dry.

Previously non-coated  metal surfaces shall be undercoated with a Primer GP-021 "DekArt".

Previously non-coated concrete surfaces shall be undercoated with a solution of paint and white spirit in ratio 1:1.

Application

Make sure that the surface is dry before coating.

Stir the paint thoroughly till monogenious substance before coating. The paint is ready to use.

Use the paint of the same batch for finishing layer to avoid deviation in shades of color. If you use  production of different batches it is necessary to mix them.

Dilute with white spirit (Nefras C4-155 / 200), solvent, their mixture or thinner TM "DekART".

The paint shall be applied evenly with a brush or a roller in 1-2 thin coats. The next layer shall be applied not before than in 24 hours.

Do not apply the paint with a thick coat!

Coating shall be applied at the temperature of air and the surface from + 10 °С till + 30 °С and maximal air humidity of 85%.

Tool cleaning

*

X

Flow calculator

Consumption standard of 1 layer
min
max

When calculating the area to be painted, you need to subtract the area that will not be painted. (windows, doors, etc.)

Paint consumption may vary depending on dilution and uniformity of application of the paint.