Specification
It increases the adhesion of construction products to the base surfaces. It penetrates deeply and hardens the surface. It lessens the consumption of paint products and increases the life period of finishing coating. It lessens the absorption of water of the base surface.
Sphere of application
It is intended for advancing adhesion to different mineral surfaces. It levels the absorbing ability before performing finishing and coating works. Ir can be applied before glueing of wallpaper, tile, parquet, flooring indoors and outdoors.
Technical data
| Consumption standard of 1 layer | 100-150 g/m2 |
| Thinner | Water |
| Application | It is applied with a roller, a brush or a spraying gun. |
| Drying period (23 °С, 50% RH) | 2 hours |
| Solids content (DSTU ISO 3251) | 27±1 % |
| Density (DSTU ISO 2811-1) | ≈ 1,02 g/сm3 |
| VOC content (ISO 11890) | < 15 g/l |
| Warranty period | 24 months from the date of manufacturing (at the temperature from +5 °С till +35 °С) |
| Packaging | 1 L |
Color
Application instruction
-
1. Surface preparation
The surface shall be cleaned from loose coats, dust, oil, grease and other dirt. It is recommended to treat the surface with antiseptic for mineral surfaces TM "Farbex" for protection against mould and fungi.
2. Applying
it is necessary to prepare the solution before use. Fill some fresh water in a clean container and add concentrated primer and stir thoroughly for 2 minutes. Depending on the type of the surface, the ratio of water and concentrated primer shall correspond the table:
|
Dilution |
Application |
Consumption of concentrated primer |
|
Without dilution |
DO NOT APPLY |
|
|
1:4 |
If the surface is extremely fragile, which peel off. |
20-30 g/m2 |
|
1:6 |
Very fragile, porous and well absorbing surfaces: gas concrete, foam concrete and alike. |
15-20 g/m² |
|
1:8 |
The surfaces with medium absorbing ability: plasters, gypsum board, woodchip boars, MDF and alike. |
12-15 g/m² |
|
1:10 |
The surfaces with poor absorbing ability: stone, concrete, brick and alike. |
10-12 g/m² |
3. Tool cleaning
-
Primers for mineral surfaces Maxima
Primers for mineral surfacesповністю
Flow calculator
Consumption standard of 1 layer
When calculating the area to be painted, you need to subtract the area that will not be painted. (windows, doors, etc.)
Paint consumption may vary depending on dilution and uniformity of application of the paint.