Farbex
Parquet varnish PP-231
Specification
- It reliably protects coated surface from the intensive mechanic load (abrasion, strikes, scratches, chips, etc.), water and detergents effects
- It emphasizes natural beauty of timber
Sphere of application
It is intended for decorative and protective coating of parquet and wooden floors, other wooden surfaces.
Content
Technical data
| Consumption standard of 1 layer | 70-80 ml/m2,it depends on the type of surface and the way of application. |
| Solvent | solvent TM DekART or oderless solvent TM Maxima, maximum of 10% from the varnish weight. |
| Application | Apply with a short-haired roller, a brush, a spraying gun. |
| Drying period (23 °С, 50% RH) | 24 hours. Drying period increases if the temperature is getting down and relative air humidity is getting higher. |
| Solids content (DSTU ISO 3251) |
> 48 % |
| Density (DSTU ISO 2811-1) | 0,9±0,02 g/cm3 |
| Gloss (DSTU ISO 2813) | > 100 GU (at 60º) |
| Hardness (DSTU ISO 1522) | > 35 sec., Konig pendulum. |
| Non-volatile matter by volume (DSTU ISO 3233) |
47±2 %. |
| VOC content (ISO 11890) | ≈ 415 g/l. |
| Warranty period | 24 months from the date of manufacturing. |
| Packaging | 0,75 l, 2,5 l, 45 l |
Gloss
Color
Application instruction
-
1. Surface preparation
The surface under application shall be dry (maximal humidity 20%), thoroughly cleaned from dirt, grease, dust, wax and polishing products.
Remove the loose pieces of old solvent-based varnish from the wooden floor and polish the surface till matt condition. The old coating shall be scraped for improving adhesion.
In the case of acrylic varnish, remove it completely from the wooden floor.
Polishing is performed in two steps. The surface is polished up with coarse-grained abrasive paper, then finished with fine-grained abrasive paper.
Defected surfaces (holes, rends, cracks) shall be filled with Putty for wood ТМ Farbex in a proper tinter. After that, the surface shall be polished up.
It is recommended to avoid methods of cleaning which can damage wood fibers (for example sandblast apparatus).
2. Priming
Previously coated wooden surfaces don’t require undercoating.
Previously uncoated wooden surfaces shall be undercoated with Wood protective primer ТМ Delfi or Wood-protective product "Base" TM Maxima.
Edges of wooden surfaces shall be treated more carefully until they are completely soaked.
3. Applying
Make sure that the undercoated surface is dry enough before applying a finishing layer.
Mix the varnish before application. If necessary, dilute it with a solvent.
The next layer shall be applied not before the drying period of 24 hours.
It is recommended to polish intermediate layers lightly with small-grained sandpaper.
Do not apply the varnish in a fat layer.
Works shall be performed at air and surface temperature from +10 ºС to +35 ºС and relative humidity less than 80%.
The surface is ready for exploitation in 72 hours.
Complete hardening of the surface and obtaining of its properties is in 14 days.
4. Tool cleaning
Clean tools with a solvent and then with warm water and detergents if necessary.
Flow calculator
Consumption standard of 1 layer
When calculating the area to be painted, you need to subtract the area that will not be painted. (windows, doors, etc.)
Paint consumption may vary depending on dilution and uniformity of application of the paint.