Specification
It is weather resistant. It has a perfect adhesion. It creates very hard coating, which resists strikes and mechanical loading. It provides reliable protection to industrial floors with intensive exploitation loading. It creates a coating, which resists the effect of detergents, water, salts and oily products. Does not withstand the impact of gasoline and diesel fuel. It dries quickly.
Sphere of application
It is intended for mineral (concrete, cement, fiber cement, brick) and reinforced concrete surfaces, which are meant to be under intensive mechanical loading indoors and outdoors. It can be applied as an initial and renovating coating of concrete floors, especially for industrial purposes (workshops, stores, trade spaces, garages, etc.), parking, reinforced concrete industrial constructions. It is also intended for road marking.
Content
Technical data
| Consumption standard of 1 layer | 140-180 g/m2, depending on the way of application and type of surface. |
| Thinner | Universal thinner TM Maxima, 10% maximum of the total paint weight. ATTENTION! Do not use white-spirit, solvent or others similar products. |
| Application | Apply with a brush, a roller or a spraying gun. |
| Drying period (23 °С, 50% RH) | 1 hour. Drying period increases if the temperature is getting down and relative air humidity is getting higher. |
| Solids content (DSTU ISO 3251) |
> 65 % |
| Density (DSTU ISO 2811-1) | 1,33 – 1,37 g/cm3 |
| Hardness (DSTU ISO 1522) | > 40 sec, Konig pendulum. |
| Non-volatile matter by volume (DSTU ISO 3233) |
51±2 % |
| VOC content (ISO 11890) | ≈ 449 g/l |
| Warranty period | 18 months from the date of manufacturing. |
| Packaging | 2,8 kg, 12 kg |
Gloss
Color
Application instruction
-
1. Preliminary preparation
It is recommended to dry and clean thoroughly the surface of loose coats, dust, chalk and lime chalk, oily, grease and other dirt.
The surfaces, previously coated with alkyd products, shall be completely cleaned of paint products in a mechanical (a scraper, a wire brush), thermal (a hot air drier, infrared radiation) or chemical (paint removing products) ways. The dust shall be removed.
New concrete surfaces shall be coated only after a month.
2. Priming
The surfaces, previously coated with solvent-borne acrylic paints, need no advanced undercoating.
Use for undercoating the paint for concrete floors AK-11 TM "Farbex", diluted to 10-20% with universal thinner TM Maxima.
3. Application
Stir the paint thoroughly before use. Dilute it with thinner if necessary.
Apply the product in 1-2 coats. A subsequent coat shall be applied in 1 hour.
It is recommended to use the product of one batch applying the finishing layer on the surface to avoid deviation in color shades. If you use products of different batches it is necessary to mix them.
Perform application at the temperature of the paint, air and the surface from + 5 °С till + 30 °С and relative air humidity of less than 80%. Do not apply the product under direct sunlight in a windy or wet weather.
The coating hardens and achieves its properties in a week after application.
4. Tool cleaning
Clean tools with a thinner and then with warm water with detergents if necessary.
Flow calculator
Consumption standard of 1 layer
When calculating the area to be painted, you need to subtract the area that will not be painted. (windows, doors, etc.)
Paint consumption may vary depending on dilution and uniformity of application of the paint.