Primer GP-021 DekArt

Primer GP-021 DekArt

DekArt

Primer GP-021

Buy

Specification

The primer allows a high level of adhesion with undercoated surface, which makes a good base for further coating and endures the lifetime of paint coating. Besides, it protects against corrosion.

Sphere of application

Primer GP-021 is intended for protective coating of metal and wooden surfaces under alkyd enamels. The primer can be used as a separate coating for temporal protection agaisnt corrosion within the period of interoperating storage.

Technical data

Consumption standard of 1 layer 80-120 g/m2, it depends on the type of the surface and way of application.
Solvent solvent TM DekART, 10% maximum of the total primer weight.
Application Apply with a short-haired roller, a brush, a spraying gun or dipping method.
Drying period (23 °С, 50% RH) 24 hours. Drying period increases if the temperature is getting down and relative air humidity is getting higher.
Solids content
(DSTU ISO 3251) 		> 60 %
Density (DSTU ISO 2811-1) 1,5 ± 0,05 g/cm3
Hardness (DSTU ISO 1522) > 35 sec., Konig pendulum.
Non-volatile matter by volume
(DSTU ISO 3233) 		59±2 %
VOC content (ISO 11890) 325±25 g/l.
Warranty period 12 months from the date of manufacturing.
Packaging 0,9 kg, 2,8 kg, 25 kg, 50 kg

Gloss

matt

Color

Primer GP-021
red brown
Primer GP-021
grey

Due to the nature of the screens, color tones may differ from actual colors.

Application instruction

-

1. Surface preparation

The surface shall be dry and cleaned from dirt, grease, dust, Clean thoroughly the surface from old loose coatings also weak layers until hard surface in mechanical (a scraper, a wire brush), thermal (hot air fan, infrared radiation) or chemical way (paint removal solutions). Metal surfaces shall be cleaned thoroughly from rust with a wire brush or abrasive cloth and degreased.

Holes, existing on the wooden surface, cracks or uneven areas shall be corrected with Putty for wooden and mineral surface TM "Farbex". The plastered surface shall be grinded off till the surface is smooth. The abrasive dust shall be removed.

2. Applying

Stir the primer thoroughly before use. The primer is ready to use. Dilute it with a solvent if necessary. Use the product of the same batch for finishing coat to avoid deviation in color shades.
If you use products of different batches it is necessary to mix them. In the case of using the primer as an intermediate layer with followed enamel applying,  it shall be coated 1 thin layer of primer, or if it should be as a stand-alone coating then 2 thin layers of primer. The primer shall be coated in 2 layers on the surface for providing a maximum protective effect.
Each next layer shall be coated in 24 hours. The coating is performed at the temperature from + 10°С till + 35 °С and relative air humidity no more than 80%. Do not apply the enamel under direct sunlight, strong wind, frost and atmospheric precipitation. After the coating is applied it shall not be affected by atmospheric precipitation for 24 hours.
 

3. Tool cleaning

Clean tools with a solvent and then with warm water with detergents if necessary.

Primer for metal DekArt
Primer for metal

повністю

X

Flow calculator

Consumption standard of 1 layer
min
max

When calculating the area to be painted, you need to subtract the area that will not be painted. (windows, doors, etc.)

Paint consumption may vary depending on dilution and uniformity of application of the paint.