Profi Base Deep-penetrating acrylic primer concentrate Delfi

Profi Base Delfi


Profi Base

Deep-penetrating acrylic primer concentrate



It penetrates deeply and hardens the surface, increases period of exploitation of the complex paint coating. It blocks efflorescence, lessens water absorption of the surface (brick, concrete, slag block, sand mortar surfaces), increases adhesion of construction materials with bases, levelling absorbing ability of the surface and thus lessens consumption of paint.

Sphere of application

It is intended for penetrating and priming of different surfaces (except metal) before application of waterborne paint products and plasters, gluing of wallpapers, tile, parquet, flooring indoors and outdoors.

Technical data

Consumption standard of 1 layer 80-125 ml/m2, depending on the condition and structure of the surface.
Thinner Water
Application it is applied with a roller, a brush or a spraying gun.
Drying period (23 °С, 50% RH) < 2 hour. Drying period increases if the temperature is getting down and relative air humidity is increasing.
Solids content (DSTU ISO 3251) ≈ 8 %
Density (DSTU ISO 2811-1) ≈ 1 g/сm3
VOC content (ISO 11890) < 10 g/l
Warranty period 18 months from the date of manufacturing
(at the temperature from +5 °С till +35 °С)
Packaging 1 L, 2 L, 5 L



Application instruction


1. Surface preparation

Uncoated surface: Clean it from loose coatings, dust, oil, grease and other dirt.

Small defects of mineral surface shall be corrected with finishing putty TM Farbex and sandpaper after that.

For protection against mould and fungi it is recommended to treat the surface with antiseptic TM Farbex.

Previously treated surfaces do not need any undercoating.

2. Applying

Depending on the type of surface, it is recommended to stir the primer with water in proportions stated in the schedule:



Primer concentrate consumption

Without diluting

In cases of extremely fragile surfaces

80-125 ml/m²


Fragile and porous surfaces with high penetrating properties: gas concrete, foam concrete and alike.

40-60 ml/m²


Surfaces with moderate penetrating properties: plaster, gypsum panels, fiber panels, wood chip panels and alike.

25-40 ml/m²


Surfaces with low penetrating properties: stone, concrete, brick and alike.

15-25 ml/m²

Apply primer evenly with a brush, a roller or a spraying gun at the temperature from +5 ºС till +35 ºС. Extremely penetrated surfaces shall be treated twice with a drying period of 1 hour.

Do not prime under direct sunlight, strong wind, frost and atmospheric precipitation. After the coating is applied it shall not be affected by atmospheric precipitation and sub-zero temperatures before finishing coating.

Subsequent work shall be carried out no earlier than 4 hours after the application of the last primer layer.

3. Tool cleaning

Clean tools with water after application. Do not let them dry.

Primers for mineral surfaces Delfi
Primers for mineral surfaces



Flow calculator

Consumption standard of 1 layer

When calculating the area to be painted, you need to subtract the area that will not be painted. (windows, doors, etc.)

Paint consumption may vary depending on dilution and uniformity of application of the paint.