Care of stone Maxima

Care of stone Maxima


Care of stone



It is intended for hardening of mineral surfaces with poor adhesion. It creates a decorative and protective coating with a "wet stone" effect. It is resistant to temperature fluctuation, weather effects, water, UV rays, detergents, and industrial and automotive oils. It provides surface water repellency. 

Sphere of application

The protectant is intended for treating mineral surfaces outdoors like natural and artificial stone, concrete, paving slate, curbs and alike.

Technical data

Consumption standard of 1 layer 50-100 ml/m2, depending on the type of surface and way of application.
Thinner Universal thinner TM "Maxima".
ATTENTION! Do not use white-spirit, solvent or others similar products.
Application Apply with a brush, a roller or a spraying gun.If apply with a spraying gun, we recommend to thin the product with Universal thinner TM "Maxima" in ratio 40-50% of the products weight.
Drying period (23 °С, 50% RH) 1 hour. Drying period increases if the temperature is getting down and relative air humidity is getting higher.
Solids content
(DSTU ISO 3251)
28-30 %
Density (DSTU ISO 2811-1) 0,91-0,93 g/сm3, depending on the gloss degree.
Gloss (DSTU ISO 2813) matt – max. 30 GU
semi-matt – 30-60 GU
glossy – min. 100 GU
(at 60º)
Hardness (DSTU ISO 1522) ab. 80 sec, Konig pendulum.
Warranty period 18 months from the date of manufacturing.
Packaging 0,75 l, 2,7 l


glossy matt semi-matt



Application instruction

1. Surface preparation

The surface shall be dry and thoroughly cleaned of dust, dirt, resin and oily contaminations. 

2. Priming

Mineral surfaces demand no priming before applying the protectant.

3. Applying

Stir the product carefully before use. Strain if necessary.

Apply with 1-2 coats. Do not apply the second coat for 1 hour after the first coat is applied.

Apply the product at the temperature of air and the surface from +10 ºС to +25 ºС and relative air humidity up to 80 %. Do not apply the product under the impact of direct sunlight, strong wind and precipitation. The coating shall not be affected by precipitation for 24 hours after application.

4. Tool cleaning

Rinse the tools with a thinner after the end of work. Don't let them dry. Then, if necessary, wash them with warm water and detergents. 


Care of stone - Бетонний декоративний блок для паркану POLYSAN
Бетонний декоративний блок для паркану

Стовпці з декоративного бетонного блоку та шви між ними покриті засобом для захисту каменя Maxima


Flow calculator

Consumption standard of 1 layer

When calculating the area to be painted, you need to subtract the area that will not be painted. (windows, doors, etc.)

Paint consumption may vary depending on dilution and uniformity of application of the paint.