The product contains UV filters, which provide firm defense from UV-rays and negative weather influence. It creates a waterproof defensive cover against moisture. Effective against wood pests and fungus. It emphasizes woody structure saving its natural beauty and quick-dry.
It is intended for long-term protection and decorative finishing of new and previously treated surfaces with acrylic wood protection products (facades of the buildings, elements of fencing, shelter range, terraces, balconies, panels, blocks, doors, window frames, furniture, etc.) indoors and outdoors.
Consumption standard of 1 layer | 100-200 ml/m2 |
Thinner | Water |
Application | Apply with a brush, a roller or a spraying gun. |
Drying period (23 °С, 50% RH) | 1 hour |
Solids content (DSTU ISO 3251) |
About 27-32 % |
Hardness (DSTU ISO 1522) | About 40-50 sec. |
Density (DSTU ISO 2811-1) | About 1,02-1,07g/сm3 |
Warranty period | 24 months from the date of manufacturing (at the temperature from +5 °С till +35 °С) |
Packaging | 0,75 l, 2,5 l, 20 l |
The surface under application shall be dry (maximum humidity is 20%). Clean thoroughly of dirt, grease, dust, blue stain, decay, old paint coatings.
Clean dirty areas with a dry brush.
Mould and plants shall be removed manually (with a scraper or a wire brush). Then treat the surface with Antiseptic for wooden surfaces TM Farbex.
Remove resin at the places of knots in mechanical way.
To receive a smooth surface without visible places of old coatings (paint or woodcare product), it shall be totally removed from the surface in mechanical (with a scratcher, a floor scrubber), thermal (a hot dryer, infra-red rays) or chemical way (paint removing treatments).
Polish the surface, remove the dust.
Make sure that wooden surface is clean and dry before priming.
It is recommended to prime new or cleaned from old rests surfaces with wood protective acrylic primer TM Maxima for providing the best defensive effect.
Edges of wooden products shall be treated more carefully and completely impregnated.
Make sure that the primed film is dry enough before putting the finish layer.
Woodcare product is ready for use, if needed thin it with water.
It is recommended to apply the product in two layers. Every next layer makes the color richer.
Works should be conducted at the environment and surface temperature from +10 ºС to +30 ºС and not more than 80% RH.
Do not apply the product under direct sunlight, strong wind, frost and atmospheric precipitation. After the coating is applied it shall not be affected by atmospheric precipitation and sub-zero temperatures for 24 hours.
Фасад повністю пофарбований акриловим деревозахисним матеріалом ТМ "Maxima" (колір: горобина). Фото зроблені в 2016 році: …
повністю
When calculating the area to be painted, you need to subtract the area that will not be painted. (windows, doors, etc.)
Paint consumption may vary depending on dilution and uniformity of application of the paint.